USGI MOLLE II ACU Padded Waist Hip Belt

Description

The molded waist belt is constructed of a molded foam pattern, covered in textured nylon duck, (2), an inner plastic reinforcement and edged with 1-inch binding tape 4).
An outer reinforcement covered with textured nylon duck (2) is sewn to the rear of the belt and onto the inner plastic reinforcement (3). Two rear mounting straps of 1-inch-wide webbing conforming to (6) are sewn onto the outer plastic reinforcement (5). Two attachment straps of the same material are sewn to the center of the rear mounting straps (6) to secure two each 1-inch tension locks
(7). In addition, two lengths of 1-inch webbing are sewn to each side of the belt for equipment attachment.
Two lengths of 2-inch-wide webbing 8) are sewn to the outer ends of the inner plastic reinforcement
(3). Male and female ends of a 2-inch side release buckle( 9) are attached to the 2-inch webbing belt (8).
The waist belt is constructed using Size F Thread 10).
NO INTERNATIONAL SHIPPING -
NSN: 8465
-
01
-
580
-
1575